![]() ![]() Entry/Exit PRESS SIMULTANEOUSLY (3 secs) Both displays Flash Three seconds approx. SET UP MODE (SET Indicator ON) NOTE: Set all Configuration Mode parameters as desired before adjusting Set Up Mode parameters. If = 1 (Auto Pre-Tune enabled - see SET UP MODE), Pre-Tune will run for every power-up. It is a single-shot routine and is thus self-disengaging. To engage: With Controller showing a normal Operator Mode display: HOLD KEYS DOWN UNTIL or For Pre-Tune For Self-Tune To dis-engage: Use same key sequence: NOTE: Pre-Tune will not engage (a) if the setpoint is ramping, (b) if the process variable is within 5% of input span of the setpoint or (c) if the proportional band = 0. Pre-Tune and Self-Tune Pre-Tune sets the Controllers PID parameters approximately Self-Tune may then be used to optimise the tuning. ![]() The Raise/Lower keys may then be used to adjust the output power. The SET indicator will flash continuously in Manual Control mode. Manual Control ( = 1 - See SET UP MODE) To select/de-select manual control, press the Auto/Manual key (see right). SP Ramp Rate is entered in eng units per hour. The Ramping SP value is not adjustable and only appears if SP Ramp Rate is not zero. The displays only appear if setpoint ramping is not disabled. The Ramping SP value cannot be adjusted and only appears if SP Ramp Rate is not zero. Alarm Indication and Status Display When any alarm is active, the ALM indicator will flash and the Alarm Status display may be accessed as follows: Error/Fault Indications These displays appear only if setpoint ramping is not disabled. NOTE: In Setpoint Strategy 2, the initial display allows setpoint adjustment. Single Setpoint Operation Dual Setpoint Operation Adjusting Setpoint and Setpoint Ramp Rate Select the display (see above) and then use the Raise and Lower keys to change the displayed value. ![]() Grado 901 - 1/16-DIN PROCESS CONTROLLER CONCISE PRODUCT MANUAL (59222-4) OPERATING MODE NOTE: Set all Configuration Mode parameters and Set Up Mode parameters as desired before starting normal operations. Hengstler grado 921 1 / 4 DIN Temperature Controllers. Real Heroes Firefighter Download Crack For Idm on this page. Hengstler grado 901 1 / 16 DIN Temperature Controllers. Hengstler Grado 921 Manual Transfer 6,2/10 3846reviewsįind great deals on eBay for manual transfer switch kit and manual transfer switch. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |